Ratchet Mechanism
The ratchet mechanism is an important part of your Metal Time mechanical model. Its job is to allow rotation in one direction while locking movement in the opposite direction. For the mechanism to work properly, the ratchet discs must be installed in the correct position and their tabs adjusted carefully.
Even small adjustments can make a big difference. Follow this guide to assemble, test, and fine-tune your ratchet mechanism.

1. Prepare and Adjust the Ratchet Discs
Before installing the ratchet discs, pay special attention to the small tabs around their edges. These tabs control how the mechanism engages with the gear.
-
Bend the tips of the tabs on both ratchet discs toward the gear.
-
Adjust the tips to an angle of approximately 15°.
-
Each bent tip should protrude approximately 0.5 mm above the disc.
-
Install the ratchet discs as shown in the assembly illustration, making sure the bent tab tips face the gear.
Correct tab positioning is essential. If the tabs are bent too little or face the wrong direction, the mechanism may not lock or rotate as intended.

2. Perform the Two Functional Checks
Once the ratchet mechanism is assembled, perform both tests before continuing with your model.
Test 1: Check rotation in the free direction
-
Hold the gear stationary.
-
Try turning the shaft in the direction indicated by the green arrow.
-
The shaft should rotate with slight resistance and produce a characteristic clicking sound.
This confirms that the ratchet mechanism allows movement in the intended direction.
Test 2: Check the locking direction
-
Keep the gear stationary.
-
Try turning the shaft in the direction indicated by the red arrow.
-
The shaft must not rotate. It should lock firmly and resist turning.
Both tests are important. The mechanism should allow rotation in one direction and prevent it in the other.

3. Troubleshooting: What If the Ratchet Doesn't Work?
If the mechanism does not behave as expected, don't worry. In most cases, a small adjustment or repositioning of the ratchet discs will solve the problem.
Problem: The shaft turns in both directions.
Check whether the tab tips are bent toward the gear. If they are already facing the correct direction, bend the tips slightly further.
Problem: The shaft does not turn in either direction.
The tabs may be bent too far. Slightly straighten the tab tips and repeat the functional checks.
Problem: The shaft turns in the locking direction but does not turn in the free direction.
The ratchet discs may be installed in the wrong positions. Swap the discs, making sure that the bent tab tips face the gear, then test the mechanism again.

4. Final Check Before Continuing Assembly
Before moving on to the next stage of your Metal Time model, make sure that:
-
Both ratchet discs are installed in the correct positions.
-
All bent tab tips face the gear.
-
The shaft rotates in the free direction with slight resistance and a clicking sound.
-
The shaft locks firmly in the opposite direction.
Take your time with these adjustments. A correctly assembled ratchet mechanism will help ensure that your model operates as intended.
A little patience during assembly makes a big difference in the final result. Happy assembling!
Building tip: Keep the visual ratchet assembly guide nearby while working. It shows the correct disc orientation, tab adjustment, and directions for both functional tests.
